/ By Kastalon / Custom Engineering • Packaging Industry • Polyurethane/ • • • • • • • • • • • / 0 Comments

Polyurethane Is A Perfect Fit For Pipe And Bar Straighteners

Pipe and bar straighteners are a great market for polyurethane parts for noise suppression, product protection and conveying. Kastalon has supplied this market place with many parts on an MRO basis. We have developed a material that has the impact resistance, cushioning and enhanced wear resistance required to provide the optimum in life for a trough liner.

We would recommend using material thicker than 3/4″, generally 1-1/4″ to 2″ thicknesses is ideal. The liner will function properly until it is worn through. Some additional positions that could and should be polyurethane/plastic covered are:

  • Protective Pads: (shock absorption, noise suppression, cut, tear and abrasion resistance, product protection)
  • Kicker shoes (these are the arms that pick up and push or kick the tube/pipe/bar, down the ramps).
  • Transfer arm covers (similar or the same as kicker arms, they also may be a wheel moving the pipe from one conveyor to the other)
  • Any hard stop surfaces for the pipe
  • V Rollers for roller transport (better friction and drive than plastic)

Kastalon produces a highly engineered a polyurethane compound in 75 Shore D hardness that is extremely effective in protecting the pipe surface and has a very long life. We find these straighteners mostly in solid bar plants where shafting and forging stock have very critical surface finish requirements (to prevent stress points in the surface of the bar which lead to cracks)

Any where there is shock, polyurethane due to its elastomeric nature, including in plastic hardness, is more effective and long lived than plastic.

/ By Lyn Thorne / Custom Engineering • Polyurethane • Steel Mill Industry/ • • • • • / 0 Comments

Polyurethane improves safety in mills

In a steel or aluminum mills, safety is always a major concern. With many employees staying in the workforce longer, there is a growing concern for reducing injuries that result from heavy lifting.

Recently, an aluminum mill established a goal to limit the maximum weight lifted manually at 50 pounds. In the roll shop this was a major concern because the bearings are held in place by a large steel split ring, known as a thrust collar that is locked into place. The maintenance process of changing out the bearing requires the worker to break the ring free and remove it. These rings can typically weigh more than 60 pounds each.

Interestingly, Kastalon was able to design a custom engineered polyurethane alternative that had all of the same strength and wear characteristics of the steel ring, but only weighed 12 pounds.

The first 4 rings well exceeded the life expectancy by lasting more than a year in continuous service and proved to reduced lost time due to back injuries in that area.

Not only did the mill find a method that would protect their workforce from unsafe practices but also found a way to achieve greater efficiency.

If you would like to learn more about our metal processing solutions, contact Lyn Thorne at lyn@kastalon.com.